1.Special Hopper must be used for loading and unloading to prevent material from falling.

  1. To sharpen the blade, you must use a special glove for the anti-cutting hand.
  2. The upper and lower version of the roll, must be on the version of the special car or special car to the version of the shaft balance position.  Hand plate version of the car to prohibit the use of gear wheel.
  3. 4. Start the equipment must be honked, notify the attention of relevant personnel.
  4. During the operation of the equipment, it is not allowed to touch and turn the guide roller.
  5. During the operation of the equipment, it is forbidden to wear gloves to scrub the ink at both ends of the cots.
  6. If the equipment boot blade or pick up knife line adjustment, must be led machine processing, second-hand monitoring, if necessary, stop processing.
  7. During the operation of the equipment, if there is foreign matter on the COTS, it must stop processing.
  8. Equipment Bite into the pressure roller, do not use hands or other items clean.
  9. When rewinding and unwinding can not be carried out normally, the machine must be stopped for repair. It is strictly forbidden to shoot the film by hand or stab the film with a paper cutter.
  10. When the paper failure is forbidden to pull by hand break film.
  11. The equipment on the membrane piercing two layers three layers, must pay attention to safety, to prevent people from falling from a height.
  12. The upper and lower impression rollers must be loaded and unloaded by two or three persons at the same time.
  13. Enter the correct version.
  14. At any time to clean up spilled ink on the ground, to avoid the operator slip. 

 

Safety Inspection Process 1. Reset the device button. 2. Put down the pressure roller pressure switch, the COTS will be locked. 3. Turn off the power and the Compressed air. 4. Clean up the ground and equipment, raw materials, ink, solvent all back to the warehouse, not allowed to stay machine.